When driving nails, make sure to place them at the highest point of the wavy roof tiles\u2014that is, at the crest of the wave. Space the nails approximately 300 mm apart. Never drive nails into the troughs of the corrugated roof tiles. If nails are driven into the troughs, the tiles are likely to crack along the nail holes when subjected to stress.<\/p>\n
As you lay the tiles row by row, draw a continuous horizontal line between each row to use for alignment and verification. Make sure the line at the very bottom eave is perfectly straight and level. Don\u2019t just assume it looks good enough and decide to call it a day\u2014that won\u2019t do.<\/p>\n
![\"\u5408\u6210\u6811\u8102\u74e6\u5b89\u88c5\u6559\u7a0b\"](\"\/wp-content\/uploads\/2026\/10\/1791335524832_0.jpg\")
<\/p>\n
In areas where the slope curves, the tiles must be bent to follow the curve. If the bending angle exceeds the tile\u2019s maximum tolerance, it must be replaced with a smaller size. Forcing the tile to bend under such conditions will inevitably result in the tiles breaking on the construction site. The practice of repairing each broken tile immediately as it occurs can lead to very serious complications down the line.<\/p>\n
What is the installation sequence for resin roof tiles?<\/h2>\n
At the ridge, use special ridge tiles to secure the joints. At the same time, apply sealant at both ends to seal the joints, in order to prevent rainwater from seeping in. For the eaves, ensure an appropriate slope is maintained.Eave Trim<\/strong>It must be kept level and free of any gaps.<\/p>\n It is generally best to keep the width of the adhesive strip between one-third and one-half of a centimeter\u2014specifically, between 5 and 8 millimeters. Be careful not to break the strip; if it breaks, you\u2019ll have to reapply it.<\/p>\n