How to install and use resin tiles with less effort?
As the favorite roof tile of the common people, synthetic resin tile is suitable for installation on what kind of roof structure? Are there any places to pay attention to and good suggestions?
Common Roof Structures
According to the commonly used roof main construction materials, can be divided into cast-in-place reinforced concrete sloped roof, wood sloped roof, steel sloped roof three construction practices.
Cast-in-place reinforced concrete slope roofing, whether there is a waterproof layer or no waterproof layer leveling layer should be set up compartmentalized joints, the spacing of the joints should be 3m~4m, the width of the joints is 20mm, and fill in with embedded materials. Concrete grass-roots level should be kept flat to ensure the installation and fixing quality of the pre-buried parts, water-supporting strips and tile-hanging strips, so as to ensure the installation quality of synthetic resin decorative tiles. If you need a water-supporting strip, fix the water-supporting strip on the pre-installed parts, and then fix the tile hanging strip on the water-supporting strip. Welding, bolts and self-tapping screws can be used for fixing according to the actual installation.
Wooden sloping roof: the wooden board surface should be flat and the moisture content should meet the standard requirements. The thickness should be selected according to the spacing of tiles, but it should not be less than 12mm, and 3mm~5mm deformation joints should be reserved when paving between the boards and the boards. If the board paved waterproofing membrane, should meet the requirements of the relevant standards for roof waterproofing construction. Coil laying should be flat, vertical, size lap accurately, shall not be twisted, folded, upper and lower layers and adjacent two coil lap joints should be staggered. Boards and purlins (tile hanging) or roof beams should be connected with bolts, galvanized nails or white tapping wood screws.
Steel roof: Steel roof should be flat, and in the process of making, it should be ensured that purlins are in the same plane to avoid unevenness of the roof node welding should be welded firmly to prevent false welding. Steel material should be selected in accordance with the standard products, and do anti-corrosion treatment.
Tile Strip Installation Recommendations
The two tile hanging strips at the upper end of the port at the ridge and the location of the tile hanging strips at the end of the roof should be installed according to the specified position, so as to facilitate the firm installation of synthetic resin roof tiles. The position of tile hanging bar above the port should be 180mm~200mm from the ridge line to facilitate the installation of ridge tiles. The position of the tiles below the end should be 60mm~80mm from the eaves, and the spacing of the tiles should be not more than 660mm, for easy installation, the spacing of the tiles should also be considered as a multiple of the pitch of the resin tiles. If adjustable-angle ridge tiles are used, an additional tile hanging bar should be added to facilitate installation.
Installation recommendations for smooth water strips
Shunshui bar selection should be based on the type of tile hanging bar and material, choose wooden tile hanging bar with wooden shunshui bar, reinforced concrete plate pre-embedded 12 galvanized mild steel wire binding shunshui bar, distance 1000mm. c-beam tile hanging bar with 8mm steel reinforcing bar shunshui bar, reinforced concrete plate pre-embedded 410mm rebar head, exposed to the surface of the board and welded with shunshui bar, spacing 1000mm. when shunshui bar is not high enough, it can be used in other ways such as using steel plate, rubber blocks, self-adhesive waterproofing rolls and other materials to pad high. Other ways such as steel plate, rubber blocks, self-adhesive waterproofing roll-roofing and other materials.
